Seatbelt question.

[greySStoke]

Dumb question I know, but where is the seatbelt retractor mechanism hidden for the rear seatbelts and how do I get to it.
Rear drivers side belt stuck half way out and won't move in or out.

In a VX if it makes a difference.


Thanks in advance.

[stumps57L]

i have this issue aswell BUMP

[Not_An_Abba_Fan]

It is behind the B pillar trim down the bottom inside the actual pillar.

[deltak]

REMOVE
1. Remove rear seat cushion and either left or right hand back seat assembly as applicable,

2. Remove bolt securing the rear seat belt lower anchor to the floor pan.

3. Remove seat belt escutcheon from C pillar trim panel by gently prising the lower front of the escutcheon away from trim.
NOTE:
The seat belt escutcheon may break if the upper section is pried from the C pillar trim panel.

4. Remove C pillar trim panel assembly. Feed seat belt sash, buckle, anchor and escutcheon through C pillar panel trim.

5. Remove bolt securing sash guide to the C pillar.

6. Remove bolt securing the rear seat belt retractor assembly to the rear quarter inner panel and remove seat belt retractor
assembly.

REINSTALL
Reinstallation is the reverse of the removal operation, noting the following:
1. Ensure all seat belt bolts are hand tightened a minimum of 5 turns before using tools.

2. Ensure that the threads of all seat belt lower securing bolts are adequately sealed with a non hardening sealer, to Holden’s
specification HN 1005 or HN 1044.

3. Tighten all bolts to the correct torque specification.
SEAT BELT SECURING BOLT TORQUE SPECIFICATION 35 - 50 Nm

4. When installing the seat belt escutcheon onto the C pillar, insert the rear upper clips of the escutcheon into the C pillar then gently push escutcheon into C pillar.

[Not_An_Abba_Fan]

Sorry, I was thinking front seat belts for some reason...