Gen T/T1000, Can anyone help please?

[ls1manta]

I was just wondering if there is anyone around the redlands area or even further if they dont mind a drive that would have a Gen T/T1000 manifold that i could dummy fit on my engine.

I have a VS with an LS1 and before i go buying a manifold i would like to see how much modifiying is going to be needed as it might be a more viable option to have a custom one built.

I wont need it for more than a few mins so any help would be greatly apprieciated.

Cheers
Dean

[hotbox]

Make sure u post results mate, its something ive been thinking about for a while.

[BlueSS]

I was just wondering if there is anyone around the redlands area or even further if they dont mind a drive that would have a Gen T/T1000 manifold that i could dummy fit on my engine.

I have a VS with an LS1 and before i go buying a manifold i would like to see how much modifiying is going to be needed as it might be a more viable option to have a custom one built.

I wont need it for more than a few mins so any help would be greatly apprieciated.

Cheers
Dean

Mate I would very much doubt it will fit, knowing how close to the rail mine sits and the VS being a lot narrower in the engine bay...

[ls1manta]

It definatley wont fit cause I sat one on it a long long long time ago.

From memory the major issue was the crossover section but since im running my crossover at the front I am hoping i can just cut that section off and re-route it.

I really need to just put one on and have another look at it all.

[ls1manta]

can anyone help?