Pedders Product Information

[Pedders]

We are often asked for product information and thought that we should drop a few links to our web site products section on the forum to help the members get better aquainted with our products.

Each section contains general information on specific products some with videos and most have downloadable PDFs as well.

We hope you find them informative.

28 Point Check (http://www.pedders.com.au/products/49)
Touring Black Gas (http://www.pedders.com.au/products/58)
Comfort Gas (http://www.pedders.com.au/products/50)
Sports Ryder Suspension (http://www.pedders.com.au/products/51)
Extreme XA Suspension (http://www.pedders.com.au/products/52)
Trak Ryder Suspension (http://www.pedders.com.au/products/53)
Pedders Load Carrying, Towing, Lift Kits & Airbags (http://www.pedders.com.au/products/92)
Pedders Springs (http://www.pedders.com.au/products/56)
Power steering (http://www.pedders.com.au/products/54)
CV Shafts (http://www.pedders.com.au/products/57)
Wheel Alignment (http://www.pedders.com.au/products/55)
Chassis Parts (http://www.pedders.com.au/products/83)
Suspension Bushes (http://www.pedders.com.au/products/59)

[SINISTER R8]

Hi,

I had your 'Extreme XA Coilovers' fitted to my car about 18 months ago, and i have noticed that there is a clunking noise coming from the front of my car in the suspension, and i have put it down to my 'Strut Top Bushes' are stuffed. I just wanted to know if these bushes and the bearing that go with them are part of the Coilover kit?

Thanks heaps.

[Pedders]

The ExtremeXa kits for the the Commodore did come with top mounts as part of the package. I suggest that you let you local Pedders guys have a look at it to confirm the cause of the noise and sort out a resolution for you.

Scott

[GRUNTS]

Hi,

I had your 'Extreme XA Coilovers' fitted to my car about 18 months ago, and i have noticed that there is a clunking noise coming from the front of my car in the suspension, and i have put it down to my 'Strut Top Bushes' are stuffed. I just wanted to know if these bushes and the bearing that go with them are part of the Coilover kit?

Thanks heaps.

i had a clunk coming from the front of my car not long after the xa's were fitted and it ended up being the sway bar bolts a bit loose, it was very hard to pick though,

[SINISTER R8]

i had a clunk coming from the front of my car not long after the xa's were fitted and it ended up being the sway bar bolts a bit loose, it was very hard to pick though,

thanks for that mate, will have a look into that too. i am going to change the strut mount bushes anyway, but will have a look at those bolts too.

[GRUNTS]

thanks for that mate, will have a look into that too. i am going to change the strut mount bushes anyway, but will have a look at those bolts too.

no worries mate, its the nut on the rods that bolt to the strut they need to be very tight or you get a loud banging

[Auto Ls1]

Hi,

I had your 'Extreme XA Coilovers' fitted to my car about 18 months ago, and i have noticed that there is a clunking noise coming from the front of my car in the suspension, and i have put it down to my 'Strut Top Bushes' are stuffed. I just wanted to know if these bushes and the bearing that go with them are part of the Coilover kit?

Thanks heaps.

Hi, any feed back as to the comfort & ride of the XA Extreme Coilovers fitted to your car compared to the fe2 suspension would be appreciated as I am weighing up my options for aftermarket suspension to fit to my car.
Cheers

[Pedders]

Hi,
The beauty of the ExtremeXa's is that you can run the car at the required height without loss of ride quality as the adjustment method always retains full suspesion travel. Te ride quality will vary depending on the where you set the shock valving. With 30 adjustment settings, you can run with a smother than standard ride at the lower range through to a full on performance orientated feel at the higher range. Even at the higher settings the ride is not unpleasant. If you search through the Posts here you will find a number of comments on the handling and feel of the suspension.

Scott

[Auto Ls1]

Hi,
The beauty of the ExtremeXa's is that you can run the car at the required height without loss of ride quality as the adjustment method always retains full suspesion travel. Te ride quality will vary depending on the where you set the shock valving. With 30 adjustment settings, you can run with a smother than standard ride at the lower range through to a full on performance orientated feel at the higher range. Even at the higher settings the ride is not unpleasant. If you search through the Posts here you will find a number of comments on the handling and feel of the suspension.

Scott

Thank's Scott for the info, looks like that is what I am after. a lower ride height without the bone jarring ride. looks like I'll have to start saving.
Cheers

[KrisR]

XA coilovers all round.... the BEST modification i've done to my CV8Z to date.

[Jas_VX_HSV_R8]

Hi Pedder's

Do LS1 members get any discounts on products, eg a set of XA Coilovers?

On the Gold Coast.

Regards
Jason

[Pedders]

Hi Jason,
Forum members are entitled to a 5% members discount off all Pedders branded products. Click here to download discount voucher (http://www.pedders.com.au/products/94/175)
Regards

Scott

[Pedders]

Pedders would like to thank the members for the support shown to us since joining the forum, so we have upgraded the Members discount structure.
Apart from ExtremeXA's and Supercar Coilovers which remain at 5% discount, all other "Pedders Branded Products" will attract a 10% discount off RRP pricing from today on.

Click on the image below to download the new voucher.

http://www.pedders.com.au/PS_images/assets/LS1/LS1-ForumVoucher10500-348.jpg (http://www.pedders.com.au/offers/94/175)

[vzmaloor8#150]

i had same issue about a week after fitment passenger front link bolts were loose, very loose sounded like strut tops but it wasnt