PROPSI
27-01-2014, 02:49 PM
Hi all, i had this motor for a project i was doing and now not going ahead (EH).
Motor is build and done about 400kms before pulling out of blown project car. Motor was built in Brisbane by performance shop. Although the motor was built for a blower/FI could also be used for NA setup. The motor has an agreesive cam combo with forged bottom end and ported and rebuild heads. Motor on the dyno was for run in only and is not yet been run in completely.
Motor block -
LS1
scat crank forged
Mahle forged pistons
scat rods
ARP bolts throughout
lunati cam 232/239 ....
lunati lifters
comp bearings
Comp pushrods
new water and oil pump
Heads -
ported runners, exhaust
bowl work
new valve int/exh, stem seals
ARP's
LS1 intake and all injectors rails and TB.
Motor is out and ready to start up. I can guaranttee motor is healthy and only been build within last 12 months. Motor even NA was super responsive when taken for a few drives....
$5k, is super cheap non negotiable.......
cheers.
Motor is build and done about 400kms before pulling out of blown project car. Motor was built in Brisbane by performance shop. Although the motor was built for a blower/FI could also be used for NA setup. The motor has an agreesive cam combo with forged bottom end and ported and rebuild heads. Motor on the dyno was for run in only and is not yet been run in completely.
Motor block -
LS1
scat crank forged
Mahle forged pistons
scat rods
ARP bolts throughout
lunati cam 232/239 ....
lunati lifters
comp bearings
Comp pushrods
new water and oil pump
Heads -
ported runners, exhaust
bowl work
new valve int/exh, stem seals
ARP's
LS1 intake and all injectors rails and TB.
Motor is out and ready to start up. I can guaranttee motor is healthy and only been build within last 12 months. Motor even NA was super responsive when taken for a few drives....
$5k, is super cheap non negotiable.......
cheers.