How to remove coolant tank??....

[Upon_1]

hey fellas,
im goin crazy trying to get me coolant tank out so i can get the top screw of my airbox out.
there's two screws holding the coolant tank in the one at the back is fine but theres no way i can see to get the one off the side cause its too **ckin low to get the screw driver in ..........
If someone one could pls assit would be greatly appriciated.

Cheers

[8throttlebodies]

Just pull hard. dont Use a screwdriver.. they are rubber stoppers around a screw.. they lift off and push back on later..

good luck, and watch your knuckles. :)
8tb

[NickS]

Just pull hard. dont Use a screwdriver.. they are rubber stoppers around a screw.. they lift off and push back on later..

good luck, and watch your knuckles. :)
8tb
Spot on ... and the airbox is the same (except for the lid)

Don't worry, I did the same thing :doh:

[DaveHAT]

My 2cents worth,
don't pull up too hard, as there is a sensor and wires in the bottom of the tank that is only plastic & can break or snap the wires.

Trust me I'm speaking form experience :rolleyes:
(Thinks to self: if all else fails DO NOT always use a bigger hammer ;) )

[theVman]

lol i spent a good 5 minutes trying to work out how i was going to get the bottom screw of the air box out . . then i remembered ppl saying you just pull the grommets over . . . for once holden has come up with a great idea!!

Just pull a bit harder than usual .. you wont break anything!!

[gts071]

I feel I should give this thread a bit of a bump as I just replaced my air box & cai with one already modified so I can keep mine original.

I spent about 30 minutes trying to figure out WTF I was doing wrong as I could not get the torque driver in to the screw (for the water tank thingo) up against the guard.

Anyway... I came here and within seconds I found this thread, said a few unfriendly words and finished the job rather quickly!

Cheers