what do i need for lumpy rumble?

[grandpa_spec]

what would i need for the car to be loud n lumpy, like its about to stall? a big cam or more than that?

[spiv]

Lots of valve overlap and low vacuum....or a cam with a poor tune... :lol:

[Danv8]

I was going to say a tank full of baked beans. :D

But lump cam, big bore exhaust, bad timing.

[kazido]

big cam, double springs, pushrods, yella terra 1.8 rockers, mafless and tune, textralia, rip shift, ported heads, Starr 85mm TB, OTRCAI, DF Headers, dual 2.5 or 1x3.5 inch exhaust, hi flow cats...and lots of spare tyres:)

and anything else i may have missed!

[XsPwr2W8]

Pull off some spark plug leads and cut the exhaust system :rofl:

[team illucid]

big cam, double springs, pushrods, yella terra 1.8 rockers, mafless and tune, textralia, rip shift, ported heads, Starr 85mm TB, OTRCAI, DF Headers, dual 2.5 or 1x3.5 inch exhaust, hi flow cats...and lots of spare tyres:)

and anything else i may have missed!

r u trying to suggest yours is lumpy ? :lol: it idles like a Nissan Pulsar :)

[chevypower]

lower restriction on the exhaust, will beef up exhaust sound only, to beef the engine sound, a camshaft job would be best

[kazido]

r u trying to suggest yours is lumpy ? :lol: it idles like a Nissan Pulsar :)
Did I say that Kurt?

No, I wasnt suggesting that I had a lumpy cam, thats why my profile says baby cammed! :booty:

Yes u are right!, it sounds like a Nissan Pulsar with an LS1 in it!!! :D

I think the mods need to keep a close eye on all the shite stirrers on this forum...beginning with TEAM ILLUCID :lol:

At least I dont have a standard cam...like some! :flip3:hahaha...If i remember correctly, yours sounds like a purring kitten on valium ;)

[team illucid]

At least I dont have a standard cam...like some! :flip3:hahaha...If i remember correctly, yours sounds like a purring kitten on valium ;)

At least mine is tuned - with your cam and all those other bits you only have about 2rwkw on mine :p

[kazido]

At least mine is tuned - with your cam and all those other bits you only have about 2rwkw on mine :p
How would u know??? you always pike out on getting a dyno run! I think its cause u know you'd barely make 200rwkw.

BTW mr illudid, u seem to be forgetting what thread u are in :deal: . This is about large cams...i think u seem to be consumed in pushing ppls buttons :stick: instead of providing usable feedback or positive info :clown:

Now Mods...before u delete this...we are just kidding! We all need to have a bit of fun now and then :goodtime: :dance: :headbang:

Back to the cam... If it's rumble u want, go for a 240/240 @106LSA an you'll sure get it...might be like a pig to drive on the streets but will sound damn hot! :cheers: