smaddock
01-05-2006, 09:10 AM
Due to a cam swap gone wrong, I have left over parts from the swap that are no longer needed due to using a different cam with custom tune.
The parts up for sale are a ChipTorque HP4 chip to suit a VS Ecotec engine. Apparently the chip can be used on a few different cams, however it will not be a perfect tune, but will get the car running. I had a Surecam High Performance Street cam (218deg. dur@50thou, 450thou valve lift) with this cam and exhaust mods and made 141rwkw. It ran fine, idled well, and wasn't too bad on fuel. However as mentioned due to a lifter failure the cam was damaged, and I ended up getting a different cam so the chip is no longer needed.
Also for sale are a set of 7.100" chromoly race pushrods to suit the above cam. These pushrods are 50thou longer than standard as the cam I used was a regrind. These were only used for around 500kms.
So basically, all you would need for a cam swap for a VS Ecotec engine is a regrind High Performance Street cam from Surecam ($208 a year ago!) and the chip and pushrods I have, and there you go.
The chip costs $500 from Chiptorque, and the pushrods costs $170 from Performance Wholesale.
Would prefer to sell together for $500.
Either PM or call me on 0418 225 044 if interested. Can also provide dyno sheet for proof of power.
I'm also open to offers or swaps... so let me know :)
The parts up for sale are a ChipTorque HP4 chip to suit a VS Ecotec engine. Apparently the chip can be used on a few different cams, however it will not be a perfect tune, but will get the car running. I had a Surecam High Performance Street cam (218deg. dur@50thou, 450thou valve lift) with this cam and exhaust mods and made 141rwkw. It ran fine, idled well, and wasn't too bad on fuel. However as mentioned due to a lifter failure the cam was damaged, and I ended up getting a different cam so the chip is no longer needed.
Also for sale are a set of 7.100" chromoly race pushrods to suit the above cam. These pushrods are 50thou longer than standard as the cam I used was a regrind. These were only used for around 500kms.
So basically, all you would need for a cam swap for a VS Ecotec engine is a regrind High Performance Street cam from Surecam ($208 a year ago!) and the chip and pushrods I have, and there you go.
The chip costs $500 from Chiptorque, and the pushrods costs $170 from Performance Wholesale.
Would prefer to sell together for $500.
Either PM or call me on 0418 225 044 if interested. Can also provide dyno sheet for proof of power.
I'm also open to offers or swaps... so let me know :)