new exhaust

[UTE346]

well finally got around to saying something about my car . had it in at chevs 2 weeks ago to get the exhaust done. what it had was vx clubby headers and dodgy cat set up but it was ok for then. car ran great making 226rwkw and 530nm tourqe running 13.6 down the 1/4 mile stock clutch and no ripshift (working on that deal with the misses) so was quite happy. then it sounded like the hole exhaust had a hole in it so it had to be fixed. so on goes a set of pacemaker 1 5/8 4 into 1 headers and some hiflow cats to go with the 2 1/2 in cat back. well the transformation was awesome the sound that came out of the back was a huge improvment (not expected) and after a tweak of the tune netted 231.6rwkw and 540nm tourqe but pulls a lot harder through the rev range.so to finish up i would like to thank gary and graham for there fine work yet again as always .


ps carnt tell if it is better on fuel the foot is stuck to the floor love that roar:yahoo:

[chev]

Great to hear you like it Marty. Now for some springs/Rip/cam/1 bar:thumbsup:

[JT]

good result guys

[throttlehappy]

well finally got around to saying something about my car . had it in at chevs 2 weeks ago to get the exhaust done. what it had was vx clubby headers and dodgy cat set up but it was ok for then. car ran great making 226rwkw and 530nm tourqe running 13.6 down the 1/4 mile stock clutch and no ripshift (working on that deal with the misses) so was quite happy. then it sounded like the hole exhaust had a hole in it so it had to be fixed. so on goes a set of pacemaker 1 5/8 4 into 1 headers and some hiflow cats to go with the 2 1/2 in cat back. well the transformation was awesome the sound that came out of the back was a huge improvment (not expected) and after a tweak of the tune netted 231.6rwkw and 540nm tourqe but pulls a lot harder through the rev range.so to finish up i would like to thank gary and graham for there fine work yet again as always .


ps carnt tell if it is better on fuel the foot is stuck to the floor love that roar:yahoo:

he does a good job doesnt he!

[alto]

what cat back exhaust did you end up with?

[JT]

what cat back exhaust did you end up with?

I think it is an x-force twin 2.5"

[UTE346]

not sure of the brand just 2 1/2 inch could be anything