e-boost 2

[psini]

G'day everyone i was just wondering if any one has fitted the eboost 2 controller to a vx commodore, if so was it hard to use and how and where did you connect the yellow rpm signal wire to for the controller?
The instructions recomend either the negative terminal of an ignition coil or to the signal wire to the ecu, but it specifies that it has to be a square wave signal. Does anyone know if the commodores have this type of signal to the ecu and will splicing into this wire cause problems for the ecu readings?
Any help on this would be very helpful.

[turbo6]

I'm sure you know this but.......... you don't have to connect the rpm signal - it is optional. The eboost will still function perfectly without it.

[psini]

Thanks for the reply turbo6, and yes i understand this but if i can i would like to connect it up so that i can use the controller to it potential ie. different boost levels at different rpm etc. etc. thanks again