fitting a VX SS front bumper

[mopar_maniac]

I am removing a fibreglass spoiler from my VT & am replacing with a VX SS bumper/spolier , i had to replace the plastic bumper guides that clip onto either side of the body of the car, after any tips/info regardnig securing the bumper correctly, i had endless trouble with the fibre glass one as it was never right from day one, so id like to get this one on there properly (could wait & get the panel beater to put it on but thats a few weeks away & my fibreglass front is just hanging there by a thread so id like to replace ASAP & get the paint work done @ a later date!), also where on my VT dash would i install the bumper for the driving/fog lights
thanks guys!

[VX2VESS]

fit the bar using the 3 top screws to hold it up first. then pull the each side into position and hit it into the side clips, fit 2 screws to the bar on each side on the end of the bar/ edge of the guard, two of those plastic screws behind where the number plate goes (same sort of screws as the raditor cover has)

and thats about it

[ssgirl2]

I think it also comes down to an amazing amount of luck in relation to getting panels to fit perfectly. The factory can't even get them right :bawl:

SS