getting dual exhaust

[myvyssute]

just trying to find someone or somewhere i can get the right side cut out so i can run exhaust out both sides. do you get it cut or can you buy them already done?

[BADTMPRD]

Both mate.

Panel beater could do it or you could buy one already done from somone like Sydney Special Vehicles.

Help this helps :)

[Y55-7UT]

i cut mine out my self, get a peice of paper and place it over your existing and rub your dirty hand over it so it shows the out line of the cut out and measure the distance on the driver side so its centered the same distance. youll also have to remove the bumperette cause there is a metal impact part of the chassis behind it that needs to be trimmed and sprayed in a rust gaurd, then also with some tough up paint put it on the edge once the bumper is cut and smoothed down, in all honesty mine looks ok, no one notices the quality untill i say i cut it then they get up close

[L-iam]

jigsaw and a hammer is how i did my VR.

and how i will do my VY when i save up for extracters and a full system.

[HSV_LS1]

If you are getting your exhaust done by castle hill exhaust, in the complex next door there is DNK Auto refinishing who should be able to cut it for you. Probably cheaper then buying it from SSV. They may be able to give you a good deal. Ask Dale or Dave if that is who they use.

[myvyssute]

If you are getting your exhaust done by castle hill exhaust, in the complex next door there is DNK Auto refinishing who should be able to cut it for you. Probably cheaper then buying it from SSV. They may be able to give you a good deal. Ask Dale or Dave if that is who they use.
thanks will. i was going to have a go myself but i thought if i stuff it it will look shhiitt