looking good =)

i used the CAE headers also, very disappointed. mine sit pretty close to the rails but i didnt have to modify anything up there although the ends on my (the flange) hit on the floorpan/chassis. had to heat the pipes up with the oxy and bend them. also mine was fine around steering arm/knuckle.

has anyone actually rang up CAE and gone nuts cause their stuff doesnt fit ?

does ur sump hit on the k-frame ? ive made up 10mm thick space plates to fit ontop of engine mounts to raise up the engine a bit more.

also my bolt holes for gearbox mount were no where near where they should of been and is showing signs of bending after a couple of drives. might have to strengthen it i think.

in the end its all worth the wait. driven mine a couple times and it just frys tyres like no tomorrow =)