ssv 3 gauge display

[shaneo68]

hey guys,after changing my 2 gauge batt/oil to the 3gauge batt/oil temp/oil press in my ssv,oil temp wont read.anyone else had this problem and how do I fix it,thanks,shane

[shaneo68]

well,apparently I have to enable the oil temp sensor through the ECM,does anyone have any info on how to do that?

[Wonky]

There is a thread on it somewhere. From memory it requires EFI Live. When I get home and back on the pc I'll see if I can find it for you.

[shaneo68]

no worries,thanks mate

[Spooner8]

A dealer can do it on March 2008 builds or later with tech 2. I had it done by a dealer. Took about 30min and cost me $50 from memory...

[shaneo68]

ok,but mines 2006 model...might have to contact them and see if it can be programmed,i was told when I bought it that it was plug and play...

[Wonky]

See http://www.ls1.com.au/forum/showthread.php?131636, particularly post #23 on. Originally HP Tuners couldn't do it but they added that functionality back then (18+ months ago).

[shaneo68]

thanks for that info mate,very helpfull.where would I find someone with EFI LIVE,would any tuner/performance shop have it?cheers

[Wonky]

Some shops use EFI Live, some HP Tuners and sounds like both will now do the job. I had nfi where Glenmore Park was so looked it up on Whereis. You're very close to Oztrack there and as stated in post #38 in that thread he's done it for HEXEM who travelled all the way up from Canberra (IIRC), so why not give him a ring and discuss it. Only 10km or so up the road and doubt you'll find anyone closer, certainly not someone who has done it before. From his website:

Unit 8 28 Coombes Dr Penrith NSW 2750
Phone 02 9119 3895

[shaneo68]

thanks mate again for all the help,i contacted steve at Oztrack he said he could do it for $200.seems expensive considering the gauges only cost me half that.
I might check around a few other shops see what they can do it for,cheers

[Wonky]

That sucks! From other posts in there it's only 10 minutes work, although I don't know how licensing works on those products. It may be that $ US100 of that is for the license??? Try doubledip (Justin) on here who's also in Sydney somewhere - he's a genius with that type of thing.

[shaneo68]

I tried to message doubledip but I don't have enough posts?

[Wonky]

Ah, OK. Go to his website http://www.ultimateconversionwiring.com.au/ - contact details on there.

[shaneo68]

thanks mate,i just emailed him,hopefully he can help me out.

[shaneo68]

a big thanks to Wonky for putting me on to Justin at Ultimate Conversion Wiring in solving my oil temp issue after I converted my ssv 2 gauge to the 3 gauge set up!! Cheers mate!!