VE Torana

[edelbrock1]

I do note the use of CAD (Cardboard Aided Design) in your fabrication. Good job.

[doubledip]

[Micks]

Justin is there anything you can't do? You could be the new IJ since the man has gone AWOL!

[cashie]

Looking great Justin, any reason you can't use a VE steering wheel and have the controls in the wheel?

[doubledip]

If i used the VE wheel then need to change the column and that in itself makes more headaches (mounting points, steering shaft to rack , lengths diff) and also then i would need to do something with horn pad as not wanting airbags. this way easier and i prefer the look of the Momo wheel

[whitels1ss]

Any updates Justin?

Amazing work mate, looking forward to seeing the end result!

[doubledip]

always being worked on but at the moment it is getting rust cut out panels replaced etc.... so although there are lots of photos its nothing really exciting to show ... i have a lot of other photos of mods done to it . when i get a bit of time will post a few more up

[doubledip]

some of the other work that has been carried out so far


rear support bar in and coil overs mounted













then started with a full VE washer bottle and cut it down to fit in the inner guard

[doubledip]

Well did another BIG jump into the deep end and started on the chassis strengthening - once again its at the stage for my mate to come round and work his welding skills ...

[doubledip]

Then cut the plating to suit ready for welding as well

[doubledip]

Also decided to make the cross member look a little better

[Micks]

Very neat job indeed!

[whitels1ss]

Fantastic work!

[GPT]

Loving this, keep it up.

[Micks]

Hi Justin any updates with your build?