Had my Rad Vol up button break on the VZ, anyone's who is interested here's a simple fix & only takes about 10mins once removed from the car.

Pic 2 shows the two very fine hinge points that become weak & break off.

1. Cut up a piece of thin plastic 1.5cm x 1cm to form a tee as pictured.
2. Then hot glue the narrow end inside the inner side of the button.
3. Once dry, use a small amount of glue on the outer side of narrow piece
of plastic.
4. Fit button back into housing, allow time for glue to fully dry.

234836579_592328625470924_1370129117713372519_n.jpg


234843231_592328612137592_5857797429261871656_n.jpg


234088644_592328592137594_179453336146158240_n.jpg


233389682_592328578804262_6930921932545160071_n.jpg