Supercharger for VFSS

[HOLDAN]

I bet it has been hard waiting Dan but I am sure you are going to end up with an amazing result.

Looking forward to seeing a video of your first run on the strip with a nine second pass.

(With even more to follow...)

It will be an amazing result Ed. Terry and his son Jaidyn are doing an awesome job in making the car look mint. Their attention to detail has blown me away.

I will post a video when we start her and race too

[whitels1ss]

Look forward it seeing it Dan.

[HOLDAN]

Look forward it seeing it Dan.

Me too Ed - and driving the wheels off it lol

[HOLDAN]

Ok here is what is left to do:
- anti roll bar- exhaust- powder coating- reassmeble rear end / diff after powdercoating- fit to car
- Front ice tank / fuel tank and fuel system
- engine fire up#
- After first fire up- everything will get checked & serviced, and anthing that has been forgotten will be noticed and tidied up.
- With it running Terry will have to get the gear vendor- all the speedo's, abs sensors etc working with the factory ecu & new trans set up#

[whitels1ss]

Sound good!

[HOLDAN]

Sound good!

Thanks Ed - it has been a lesson in patience that's for sure.

[HOLDAN]

Here's another update.

The fuel tank design is complete. Baffles ordered, cut and arrived. Anti-roll bar assembly has arrived.

This week the baffles will be welded in the tank. ARB assembled and installed and the end pieces of the exhaust will be fabricated and fitted.

[white lie]

Nice looking tank, what's the capacity looking to be?

[whitels1ss]

Nice looking tank, what's the capacity looking to be?

Wow! that looks like a very fancy piece of work!

[HOLDAN]

Not sure what the capacity will be at the moment.

Yes it is a very cool design and fabrication. And I love the brushless electric fuel pump

[HOLDAN]

Many thanks again Chris for posting my pics

[white lie]

Quick video of the exhaust setup from Dan

http://cloud.tapatalk.com/s/64e5b043...F066E5FB39.MOV

[HOLDAN]

As always - many thanks for posting for me Chris.

[HOLDAN]

It is worth noting that the bends in the 3.5" pipe were too tight for the Mandrel bender. So the bends were fabricated using about 20 sections . That's an outstanding effort IMHO

[whitels1ss]

Hey Dan, I cannot see the video posted by Chris yesterday.

Can anyone else see it?