Thought I'd share my recent VF2 Harrop brake upgrade.
Following the purchase of my Ute in February I inspected it's braking system while it pulled up ok though just didn't add up.
I looked around over the last few months at other upgrade options, though few would allow the existing 19" oem wheels.
Looked at the Brembos though required a greater offset rim & when I inspected the 4 pot front upgrade offering was
lower in spec & quality to the Harrop units.
They included the complete fitting kit, bolts with braided lines also.

WP_20160426_008.jpg


WP_20160426_004.jpg


WP_20160426_015.jpg


Very pleased how precise & logical the kit was to install. They obviously put considerable R&D into these systems as the
clearances using oem parts are still very generous. Like how easy it is to swap out pads too.
When bleeding these units took a considerable time to purge out the air as they use a single nipple.
The braided lines are very well made quality item & great fit too.
Once the brakes were fully bled & then road tested, I done the mandatory 30 light uses of the system I returned & fully checked the system.
Went for another run & all I can say is very impressed with the Harrops far superior to the oem offering & far little effort to pull it up too!
Like to thank IJ for introducing me to Julian who sorted me out pretty quick with what I required thanks mate

WP_20160426_017.jpg

Found a good 20mm spoke to caliper clearance with this setup.