To stall or not to stall

[whitels1ss]

Yes maybe Ed could chime in perhaps? Reckon a good hose doctor could whip up the pipes without too much trouble then probably just a few hours to fit it all up.

Sorry but I am way over the other side of the city Mick
& the guy I would use is booked out for a couple of months at the moment.

[lmoengnr]

Was doing some more research on location of Police spec cooler and came across this:


"Genuine secondary trans cooler (police spec?) sits in front of the top of the radiator and has hard pipes that come down in front of the engine and connect in line with the factory cooler in the radiator. Not good spot if you want to add an over the radiator cold air intake"

If this is true then I am unable to use this cooler, as I have VCM OTR

The factory cooler on my Maloo interfered with my Ramjet intake, so I ditched the mounting bracket for the cooler for clearance.
The hard lines give it plenty of support, with a couple of nylon ty wraps to stop it moving around.

[BLACK 346]

The factory cooler on my Maloo interfered with my Ramjet intake, so I ditched the mounting bracket for the cooler for clearance.
The hard lines give it plenty of support, with a couple of nylon ty wraps to stop it moving around.

That sounds promising. Mine didn't come with any brackets, but if it can be mounted without them, then that could be my only hope. Thanks mate.

[BLACK 346]

As some of you may be aware, I purchased an OEM VE Trans cooler (Police fitment) from Gary (Wonky), thanks mate
Before I leap in and get it installed I was wondering if anyone had installed one of these and could tell me exactly where it bolts on? Just want to make sure I have all my shit in a pile before I put it in and trans fluid starts getting dumped. It has 2 bolts each end that appear to be for mounting points, but a quick look at the car does not show any obvious mounting points. Any advice on area I should be looking in would be appreciated

Got this fitted by City Holden at Hillcrest a few days ago, they were able to source the correct brackets and it fitted up nicely. Cost me $300 (I supplied Penrite trans fluid) and that included fitting my GTS Steering wheel as well. Been extremely happy with the work done at that dealer since Josh Halls took over as service manager. I was originally concerned that it would not fit with my VCM OTR, but no issues with that either, so very happy. Thanks again to Gary (Wonky)

[Micks]

How is the new wheel compared to the Calais oem one mate?

[BLACK 346]

How is the new wheel compared to the Calais oem one mate?

Night and day Mick, love it