Methanol/water injection

[BLACK 346]

A few shops are quoting $12k DIDO but I might go another way with a short engine build.

That is a good price.

[whitels1ss]

10 pound. It will be getting retuned after exhaust goes on so will get up to date dyno figure then.

Any updates yet Rod?

[BLACK 346]

Any updates yet Rod?

Brad is in the middle of moving his shop to a new location, so have not been able to get it in. Hoping to get in later in year once he is set up in new premises.

[whitels1ss]

Brad is in the middle of moving his shop to a new location, so have not been able to get it in. Hoping to get in later in year once he is set up in new premises.

Good stuff,

Where is he moving to Rod?

[BLACK 346]

Good stuff,

Where is he moving to Rod?

Up near TTP I believe.

[BLACK 346]

Went and had a coffee with Brad and Cath again today. They are getting sorted in the new shop. Bloody big job moving a workshop, I do not envy them.

[whitels1ss]

Went and had a coffee with Brad and Cath again today. They are getting sorted in the new shop. Bloody big job moving a workshop, I do not envy them.

What is the address there Rod?

[BLACK 346]

What is the address there Rod?

29 Golden Grove Rd, Ridgehaven SA 5097. Right next door to Pedders.

[whitels1ss]

29 Golden Grove Rd, Ridgehaven SA 5097. Right next door to Pedders.

I actually went past there this morning, can't miss the big signage.

[BLACK 346]

I actually went past there this morning, can't miss the big signage.

Yeah, it is bloody huge lol.

[BLACK 346]

Two graphs, first one prior to water methanol, 2.5k Stall converter and changed to Twin 3 inch Magnaflow exhaust (was 3 inch ET/Streetfighter). Interesting how much the torque has increased with the addition of the stall converter. Now awaiting three extra nozzles and jets for the water/meth system to get those intake temps down even further. This is on 10 pound of boost, and Brad will not entertain the idea of going higher on the stock bottom end, and even more so the stock trans.

[whitels1ss]

I see that last was done at 29 degrees ambient temp,
do you know what sort of IAT's it was running?

[BLACK 346]

I see that last was done at 29 degrees ambient temp,
do you know what sort of IAT's it was running?

Was getting up to 90 degrees, Brad wants to see it under 70.

[whitels1ss]

Was getting up to 90 degrees, Brad wants to see it under 70.

Be good to see when it's done.

Have you monitored them at all on cruise?

[BLACK 346]

Be good to see when it's done.

Have you monitored them at all on cruise?

No Ed, I have no equipment to do that. What do you recommend for me to purchase that will enable this?